None 8239204388 Guide d'installation télécharger pdf

Figure 16

Figure 17

Socket

Light Kit Option

CAUTION - To reduce the risk of electrical

shock, disconnect the electrical supply circuit

to the fan before installing light kit.

FAN WITH LIGHT KIT (Figure 17)

1. Remove the three mounting screws on the

black bracket below the motor.

2. Remove the the nial, lower cap, hex nut

and rubber washer from the light xture.

3. Remove the nut and washer from the top of

the light xture.

4. Attach the light kit to the switch housing

by rst removing the decorative cover on

the bottom of the switch housing. Insert the

wires from the top of the light kit through

the hole in the bottom of the switch housing.

Thread the light kit into the hole on the bot-

tom of the switch housing. Secure with the

nut and washer provided.

5. Connect the wires from the light kit to the

blue and white wires in the switch housing

marked for light kit connection. See page 6

for wiring.

6. Connect the wires exiting the bottom of the

motor with the switch housing by connect-

ing the molded adaptor plugs together.

7. Slide the switch housing and secure it to the

black bracket using the three screws that

were removed in step1.

8. With power off, install candelabra E12 base

bulbs (Max. 60W, included) to the lamp

sockets.

9. Place the glass bowl over the threaded stem of

the light xture and up against the upper cap.

10. Place the decorative leaves, rubber washer,

hex nut and cap over the threaded stem of

OVER LAMPING THE FAN WILL RESULT IN

THE FAN LIGHTS SHUTTING DOWN UNTIL THE

PROPER WATTAGE OF BULBS ARE INSTALLED.

RESET THE LIGHTS BY TURNING OFF, RE-

PLACE BULBS WITH THE POWER ON.

the light xture, direct the fan pull chain

through the side hole on the glass.

11. Place the nial over the threaded stem and

direct the light pull chain through the hole

of the nial, tighten the nial securely.

12. Attach the pull chain extensions provided to

the light pull chain and the fan pull chain.

blade levels are unequal. Check this level by

selecting a point on the ceiling above the tip

of one of the blades. Measure from a point

on the center of each blade to the point on

the ceiling. Measure this distance as shown

in Figure 16. Rotate the fan until the next

blade is positioned for measurement. Repeat

for each blade. Measurement deviations

should within 1/8”. Run the fan for 10 min-

utes.

3. Use the enclosed Blade Balancing Kit if the

blade wobble is still noticeable.

Light Kit Option 1

Résumé du contenu

Page 1 - Light Kit Option

9.Figure 16Figure 17SocketLight Kit OptionCAUTION - To reduce the risk of electrical shock, disconnect the electrical supply circuit to the fan before

Plus de documents pour Ventilateurs des ménages None 8239204388

Voir le document None 8239204388 Manuel d'utilisation et d'entretien

None 8239204388 Manuel d'utilisation et d'entretien (15 pages)

Commentaires sur ces manuels

Pas de commentaire

None 8239204388 Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Ventilateurs des ménages None 8239204388. none 8239204388 Installation Guide Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Ventilateurs des ménages None 8239204388

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs des ménages None 8239204388