None 32762 Guide d'installation télécharger pdf (Page 8)

Assembly - Close-To-Ceiling Mount

Assembly - Hanging the Fan

Attaching the fan to the electrical

box

□ Pass the 120-Volt supply wires through the center hole in the

mounting bracket (A).

□ Install the ceiling mounting bracket on the outlet box by sliding

the mounting bracket (A) over the two screws (II) provided with

the outlet box. If necessary, use leveling washers (not included)

between the mounting bracket (A) and the outlet box. Note that

the at side of the mounting bracket (A) is toward the outlet box.

When using close-to-ceiling mounting, it is important that the

mounting bracket be level.

□ Securely tighten the two mounting screws (II).

WARNING: To reduce the risk of re, electric shock or personal

injury, mount to outlet box marked “Acceptable for fan support

of 35lbs. (15.9 Kg) or less”, and use screws provided with the

outlet box.

IIII

Close-to-Ceiling Mounting Routing the wires

1 2

□ Remove canopy ring (D) from the canopy (C) by turning the

ring counterclockwise until it unlocks.

□ Remove the mounting bracket (A) from the canopy (C) by

loosening the two canopy screws (HH) located in the “L

shaped” slots.

□ Remove and save the two canopy screws (HH) and lock-

washers (GG) in the round holes. This will enable you to

remove the mounting bracket (A).

□ Remove the decorative canopy bottom cover (N) from the

canopy (C) by pressing the three studs located inside the

bottom of the canopy.

□ Remove three of the six screws (KK) and lock washers (LL)

(every other one) securing the motor collar to the top of the

fan motor housing (E).

□ Place the rubber gasket (AA) over the remaining three screws,

route the wires exiting the top of the fan motor (E) through

the canopy ring (D). Make sure the slot opening is on top, then

proceed to place the ceiling canopy (C) over the collar at the

top of the motor (E).

□ Align the mounting holes with the holes in the motor (E) and

fasten, using the three screws (KK) and lock washers (LL)

removed previously. Tighten the mounting screws securely.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

None 32762 Guide d'installation Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs des ménages None 32762