None 13431100923200 Manuel d'instructions télécharger pdf (Page 10)

Attaching the Fan Blades

1. A ttach the fan blades to the blade holders by

using three screws and fiber washers as shown

in Figure 15. Start a screw into the blade

holder, do not tighten. Repeat for the 2

remaining screws and washers.

2.Tighten each screw securely starting with

the center screw.

Repeat process for the other blades.

3. Remove the screws and rubber block from

the bottom motor before fasten the blade

a s s e m b l i e s t o t h e b o t t o m m o t o r

housing.

4.Tighten the blade assemblies onto bottom

motor by using two screws from the loose

parts. Repeat process for the other blade

holders. (Figure 17)

(Figure 16)

The following procedure should correct

most fan wobble. Check after each step.

1.

Check

that all blades and blade holder

screws are secure.

2. M ost fan wobble problems are caused

when blade levels are unequal. Check this

level by selecting a point on the ceiling

above the tip of one of the blades. Measure

this distance as shown in Figure 18. Rotate

the fan until the next blade is positioned for

measurement. Repeat for each blade. The

distance should be equal within 1/8".

(Figure18)

If all blade levels are not equal, you can

adjust the blade level with the following

procedure.

3. Use the enclosed Blade Balancing Kit if

the blade wobble is still noticeable. Please

refer to the introduction provide in the

blade balancing kit, which is individual

packed.

4. If the blade wobble is still noticeable,

in terchanging tw o adjacent(side by

side)blades can redistribute the weight and

possibly result in smoother operation.

Figure 17

Touching

ceiling

Figure 16

Screw

Washer

Blade

holder

Blade

Screws

Fiber

Washer

Figure 15

Figure 18

7

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Commentaires sur ces manuels

Pas de commentaire