None 13431100502303 Manuel d'instructions télécharger pdf (Page 10)

Assembly — Attaching the Fan Blades

Fastening the blade

assemblies to the motor

□ Attach the fan blades (A) to the blade bracket (B) using

the blade screws (AA) and ber washers (BB). Tighten

the screws (AA) securely.

□ Remove the ten blade bracket screws (CC) from the

bottom of the motor.

□ Align the motor holes to the blade bracket (B) and

secure with the blade bracket screws (CC). Tighten

the screws (CC) securely.

□ Repeat this procedure with the remaining blade

assemblies.

□ Disassemble the switch house cover (I) by removing

the three screws (VV) on the switch house (J).

□ Remove the three screws (WW) in the light kit (F). While

holding the light kit assembly under your fan, snap

together the wire connection plugs (XX).

□ Carefully push all wires back into the switch house (J),

then install the light kit assembly (F) onto the switch

house (J) with the three screws (WW) removed and

securely tighten all screws.

□ To install light kit glass shade (G), loosen the light kit

screws (YY) and install the glass shade (G) to the light

kit (F). Secure by tightening the light kit screws (YY)

previously loosened.

□ Install 3×60W A15C bulbs (GG) (included).

□ Restore power and your light kit is ready for use.

□ Attach the fan pull chain fob (EE) to the chain on the

switch house (J), and attach the light kit pull chain fob

(FF) to the chain on the light kit assembly (F).

Finish the light kit assembly

and glass shades mounting

Assembly — Installing the Light Kit

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Pas de commentaire

None 13431100502303 Manuel d'instructions Page 10